VIEW CART
NZD $0.00
(0)
LOG IN 
HOME > RESIN, FILLERS AND SEALERS > DOMING RESIN
Email A Friend
QUANTITY
-
+
NORSKI
epoxy doming resin and hardener | 3 litres
DR300
PRODUCT DESCRIPTION

2L Epoxy Doming Resin + 1L Hardener = 3 Litres

Epoxy Doming Resin is a two-pot Epoxy Resin formulated for use in the following areas � top-coating decorative wooden tops, wooden plaques, badges, cold epoxy enamelling and decoupage.

Preparation and Application:

1.Use a clean dry container, add two parts Base to one part Hardener(2:1),stir until the materials are thoroughly blended together, mixing should be completed after two minutes of vigorous mixing.

2. The importance of thorough mixing cannot be over emphasized - if bubbles are whipped into themixture these can be removed later. Note: Improper mixing can result in soft/sticky spots.

3.Once you have thoroughly mixed the resin mixture, carefully pour over the surface in an even pattern, spread where necessary using a piece of stiff paper to help the liquid flow together.

4. lf the mixed Doming Resin is left in the mixing container, it will become hot and set rapidly.

5. After the Doming Resin has been applied to the article, any air bubbles created while stirring will rise to the surface taking approximately five minutes to appear, these bubbles can be easily broken by gently using a propane torch.

6.Hold the torch approximately 150mmaway from the article and sweep smoothly across the surface until the bubbles have disappeared; this process may be repeated as often as is necessary while the material is still in liquid form. Brush the edges until the material has set firm enough not to sag.

7. It is the carbon dioxide, not the heat which breaks up the bubbles. 

Cure:

1. For the best results, coat at temperatures between 22�C and 28�C.

2. Allow the coated item to cure in a warm dust free room.

3. Cure time will vary with humidity and temperature, humidity below 50% is recommended for proper hardness of the film.

4. Placing a clean cardboard box over the item is effective in keeping dust off the surface during the curing cycle.

Temperature Dust Free Cure Time
- 22�C 4-7 hours 72 hours
- 28�C 3-6 hours 48 hours
- 32�C 2-5 hours 36 hours

 

STOCK AVAILABLE
NZD $163.56
ADD TO CART
1.5 Litres
3 Litres
6 Litres
12 Litres
375mL
750mL
RELATED PRODUCTS
Resin Brush | 25mm
Colour Dye - 25mL | Blue
Back to Top