NZD $0.00
Email A Friend
spray booth coat - clear | 20 litres

TBS Booth Coat is a clear temporary paint spray booth clear strippable coating for spray Paint booth lights and glass doors where paint over spray accumulation must be readily removed. It will maximize Paint booth illumination and remain non-dusting. Thus, application of clear peelable booth coating TBS Booth coat will result in optimum paint finish and minimize rejects. 

Can be used as a peelable coating on steel surfaces to eliminate flash rusting or as a protection on glass, Plexiglas, rubber, cement, aluminum and many other hard surfaces.

TBS Booth Coat represents the ultimate in non-solvent strippable coatings. It is well stabilized against brittleness and it will not be softened or penetrated by solvent-based paints. 


  • Results in a reduction of labour costs by reducing the application time.
  • Once cured, it provides an extremly tough, uniform film thickness.
  • Curing time can be cut in half with the use of increasing temperatures up to 100�F
  • Easily removed: peels off in sheets which eliminates messy hand scrapping
  • Safe - non flammable

Paint spray booth white strippable coating when applied improperly can cause problems. Proper application results in a tough film of uniform thickness with no sags, less application time and minimal clean-up labour. TBS Water-Based white strippable coating may be used wherever protective strippable coatings are needed or to reduce clean up problems. Spray Booths, Floors, Windows, walls, Machinery, equipment spray booths and fixtures have all been applications for our strippable coating. If you have an overspray problem, a clean up problem or an emissions problem, call us.

1. Apply 10-12 mils wet water based peelable film to clean, dry peelable (booth walls, fixtures) in a smooth, continuous spray. If using airless equipment, use .015 or .017 nozzle at a set pressure of 1200-1500 PSI. With conventional air spray, we recommend nozzle #68PB with needle #368 at a pressure of 35-55 PSI.

2. After significant paint overspray build up, film may be quickly and easily removed. Cut film to start peeling from one corner. Production time between cleaning is increased; quality control is improved with better illumination.

3. Simply peel off in large, continuous sheets. Booth is left clean and ready for next application. Messy hand scraping or solvent removal eliminated. Clean-up is fast. Waste disposal costs cut.

4. The coating provides a tough, flexible solvent-resistant film which protects booth walls, paint fixtures, metal parts in storage, or any non-porous metal surface from paint overspray.

TBS Booth Coat is normally used as received. The airless spray gun equipment applies it, by roller coating or by brushing. Sprayed strippable coating is air-dried from 30 minutes to 3 hours, depending on thickness of coating. usually applied to form a film, thickness in the range of 1 to 3 mils (.001" to .003"). Strippable Coating is usually resistant to attack by paint solvents. Spraying temperature shall be 60� F minimum. For best results, apply at room temperature. 

NZD $449.45
5 Litres
20 Litres
Back to Top