Autothane CV Mixed Colour | 4 Litre
If you know the colour you are after, put all the colour information (colour code, etc) we need to mix it up for you in the Notes section at Checkout. If you are unsure please get in touch with us.
Autothane CV is a 2 Pack Polyurethane Topcoat suitable for use in the industrial and commercial transport markets. It is quick drying and gives a tough, high gloss finish with a fast into service and tape free time. This product range can produce approximately 6000 popular colours.
Autothane CV can be applied over the following substrates:
- Original factory finish or works primer
- Suitable 1K and 2K Primer Surfacers
Careful preparation of substrates will ensure a top quality finish.
Wet or Dry paper P600-800. Mirka Dry Machine Sanding P280-320 Mirka.
The preparation levels quoted should be used for colour on colour work if optimum appearance is desired.
Products: 412- Line Autothane CV 2 Pack Topcoat
980-49641 4:1 Hardener
980-57645 2:1 Extra Gloss Hardener
980-49879 4:1 Slow Hardener
920-49499 Normal Thinner
920-49502 Slow Thinner
Autothane CV 412-line: 4:1 Option 4 vols | 2:1 Extra Gloss Option 2 vols
Autothane CV Hardener*: 4:1 Option 1 vol | 2:1 Extra Gloss Option 1 vol
Autothane CV Thinner*: 4:1 Option 20-40% | 2:1 Extra Gloss Option 10-20%
* Choose Hardener and Thinner according to application temperature and size of vehicle:
|4:1 Hardener||2:1 Extra Gloss Hardener||Thinner|
|Up to 18'C||980-49641||980-57645||920-49499 Normal|
|18'C - 25'C||980-49641||980-57645||920-49499 Normal|
|25'C - 35'C||980-49879 Slow||980-57645||920-49502 Slow|
|Over 35'C||980-49879 Slow||980-57645||920-49502 Slow|
Potlife at 25'C: 4:1 Option 5 hours @ 25'C | 2:1 Extra Gloss Option 4 hours @ 25'C
Spray Viscosity: 4:1 Option 15-18 seconds DIN4 @ 25'C | 2:1 Extra Gloss Option 12-16 seconds DIN4 @ 25'C
Spraygun Setup: Gravity Feed 1.3 - 1.5mm | Suction Feed 1.4 - 1.8mm
Spray Pressure: 315-455 Kpa 45–65 psi
Number of Coats: 2-3 single coats to give a dry film build of 45-60 microns
Flash Off at 25'C:
Between coats: 10 minutes minimum
Before stoving: Bake immediately
Dust-free @ 25'C: 10-20 minutes
Thorough dry at 65'C: 40 minutes*
*Stoving times are for quoted metal temperature. Additional time should be allowed in the stoving schedule to allow metal to reach recommended temperature.
Total Dry Film Build: Minimum 45 µm | Maximum 60 µm
Sanding: Grade Wet P600 - P800 | Grade Dry P320 - P400
Recoat Time: After stoving for 40 minutes @ 65'C when cool, or overnight air dry @ 25'C. Surfaces which have been polished must be sanded prior to recoating.