D8260 Activator for WB Engine Bay Converter 500mL

D8260 Activator for WB Engine Bay Converter 500mL

DELTRON

  • $169.60
    Unit price per 
Shipping calculated at checkout.


Envirobase High Performance Internal Repair System is designed to provide a simple and efficient process for repairs involving a specific matt interior colour, or low gloss versions of the external colour.
Direct application to electrocoat produces a groundcoat colour to accurately reproduce the original finish on internal parts. At the same time it provides a coloured wet on wet layer that can be topcoated to reproduce the original external finish, thereby removing the need for undercoating.
Envirobase High Performance Internal Repair system has two modes of use. Internal colour formulas matched to dedicated OE internal colours are provided as part of the PPG colour retrieval system. Alternatively any waterborne colour can be converted to Internal Repair mode for use in many repairs where internal colours are low gloss versions of external areas. 

Mixing Ratios - Dedicated Internal Colour:
Mix the Internal colour in accordance with the PPG colour retrieval systems.
This formulation will contain T510 WB Engine Bay Converter.
NOTE: The colour must be stirred thoroughly when the converter is added, BEFORE activation and thinning.

Making ready for use by weight:
Engine Bay Colour 100 parts
D8260 Activator 15 parts
T494* 15 - 20 parts for Solid Colours, 20 parts for Aluminiums / Pearls
To give an application viscosity of 18 - 21 Seconds
*10 parts thinner may be used for double coating

Mixing Ratios - Converting an Existing Colour:
Where the internal area is a matt version of the external colour, mix the Envirobase colour in accordance with the PPG colour retrieval systems.

Making ready for use by weight:
Envirobase Colour 70 parts
WB Engine Bay Converter T510 30 parts
Stir thoroughly then add:
D8260 Activator 15 parts
T494* 15 - 20 parts for solid colours, 20 parts for Aluminiums / Pearls
To give an application viscosity of 18 - 21 Seconds
*10 parts thinner may be used for double coating

Potlife 1 hour at 20'C - when activated

Spray Viscosity 18 - 21 secs DIN4 / 20'C

Spraygun Set Up: HVLP Spraygun 1.3 - 1.4 mm – SATA WSB Recommended | Spray Pressure 1.3 -1.8 bar

Number of Coats: Apply one double coat or 2 single coats to opacity to give a dry film thickness of 10 - 25 microns.

Flash Off at 20'C: Between Coats: Ensure that each coat is fully flashed off before overcoating. Blow dry using SATA blower. 5 minutes or until matt appearance between coats if using single coats. Activated Internal repair basecoat should not be left uncoated on external areas.

If required for external areas: PPG recommend the use of a matted clearcoat to seal the basecoat.